15
als such as antenna cables and external antennas) should
be used no closer than 30 cm (12 inches) to any part of the
2in1 Double Breast Pump, including cables specified by the
manufacturer. Otherwise, degradation of the performance of
this equipment could result.
40. Use of this equipment adjacent to or stacked with other equip-
ment should be avoided because it could result in improper
operation. If such use is necessary, this equipment and the
other equipment should be observed to verify that they are
operating normally.
3. Cleaning and maintaining the appliance
Before using your MAM 2in1 Single Breast Pump for the first time and after each use, all parts that come
into contact with the breast and breast milk must be separated, cleaned and sterilised.
• Only drinking-quality water must be used for cleaning.
• Do NOT sterilise the tubing or pump unit.
• Do NOT clean the inside of the tubing as no milk should enter it!
• Completely air dry or towel dry before reassembly and next use. Partially wet components may affect
the operation of the electric breast pump.
• Ensure that the tubing is free from any liquid. Do not operate the electric breast pump if any liquid is
visible in the tubing (see chapter 6 – Troubleshooting).
• Take care not to damage parts of the pump set during cleaning.
3.1. Cleaning by hand
Before cleaning, all parts of the pump must be separated. Begin by rinsing all parts in cold, clear water.
Then wash all parts in warm soapy water with a damp cloth or sponge and rinse thoroughly with cold
water afterwards. Do not use any abrasive cleaning agents such as anti-bacterial solutions, as these
could attack the appliance’s surface. Leave the separated parts to drip dry or use clean paper towel.
3.2. Cleaning in the dishwasher
To clean the breast pump in the dishwasher, place the separated parts on the top rack of the dishwasher
or in the cutlery section. When washing the pump parts in the dishwasher, the components may become
discoloured by food pigments – this does not affect their function. We recommend to carefully clean the
valve body and valve membrane by hand to prevent damages and to ensure that those small compo-
nents do not get lost.
3.3. Cleaning the electric pump unit
To clean the electric pump unit, unplug the appliance, switch it off and wipe it with a clean, damp cloth.
Never place it in a dishwasher for cleaning. The appliance must not be immersed in water.
3.4. Sterilising the breast pump
Before using the pump for the first time and once a day, all parts of the pump except the tubing and the
electric pump unit must be sterilised.
The separated pump parts can be sterilised in boiling water, in an electric or microwave steam steriliser
as well as in cold sterilising liquid. Store the pump set in a clean bag / container and use the funnel cover
for further protection of the silicone cushion until next use.
Please note:
never sterilise the assembled pump – always separate the parts.
Important:
allow all parts of the breast pump to fully cool and dry before use.
