MicroCal iTC
200
Washing Module User Guide
13
11. Run the tubing from the bottles to the bottle
adapter as follows:
Blue bottle to the water inlet port
Red bottle to the methanol inlet port
White bottle to the buffer inlet port
Note: Do not over-tighten.
12. Remove the securing nut from the top of the
waste bottle and slide the open end of the
waste tubing though it. Then slide the ferrule
with the cone end facing towards the
securing nut over the tubing as shown.
Note: The opposite end of the waste tube
should be installed in the C5 port on the
washing module. See step 5 above.
13. Insert the waste line (connected to the C5
port on the washing module) into the Grey
(waste) bottle and tighten the securing nut
until it is finger tight.
MicroCal iTC200 Washing Module MAN0582
