Site requirements
Chapter 2
Zetasizer
μ
V Essentials
Page 2-5
General requirements
The following requirements apply to all countries:
The power cord must be approved by an acceptable accredited agency respon-
sible for evaluation in the country where the power cord set will be installed.
The power cord set must have a minimum current capacity of 10A (7A in Japan
only) and a nominal voltage rating of 125 or 250 volts AC, as required by each
country's power system.
The area of the wire must be a minimum of 0.75mm
2
or 18AWG, and the
length of the cord must be less than 3m.
The power cord must be routed so it will not be walked on, pinched by items
placed on or against it, or become wet. Pay particular attention to the plug, the
electrical outlet and the point where the cord exits the product.
Computer specification
As with any software, running other software at the same time may affect the speed
of the Zetasizer software.
Minimum recommended specification
Pentium P4 PC 2.8GHz, 512MByte RAM, 160GByte hard disk drive, 1024 x 768
screen resolution, CD-ROM drive, USB port, Windows XP Pro (SP2) operating
system.
Note:
A laptop computer must have a free USB port to operate with the system.
Networks
The PC running the Zetasizer software can be connected to a network, but the
Zetasizer software must be run locally.
Man0429-1.0 (Zetasizer uV Essentials).book Page 5 Friday, December 19, 2008 9:32 AM
Summary of Contents for Zetasizer uV
Page 6: ...Page 4 Addendum 0078 1 0...
