Avoid unintentional starting
Do not carry a plugged-in tool with a finger on the switch. Ensure switch is off when
plugging in.
Use outdoor extension leads
When tool is used outdoors use only extension cord intended for outdoor use.
Stay alert
Watch what you are doing. Use common sense. Do not operate tool when you are tired.
Check damaged parts
Before further use of the tool, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function. Check
for alignment of moving parts, free running of moving parts, breakage of parts mounting
and any other conditions that may affect its operation. A guard or damaged should be
properly repaired or replaced by an authorized service center unless otherwise indicated in
this instruction manual. Have defective switches replaced by an authorized service facility.
Do not use the tool if the switch does not turn it on and off.
Warning
The use of any accessory or attachment other than those recommended in this instruction
manual, may present a risk of personal injury. Have your tool repaired by a qualified
person. This electric tool is accordance with the relevant safety requirements. Repairs
should only be carried out by qualified persons using original spare parts otherwise this
may result in considerable danger to the use. If the supply cord is damaged it must be
replaced by a special cord or assembly available from the manufacturer or its service
agent.
Before starting the machine connection
This hedge trimmer may only be connected to single-phase AC current. Ensure that the
mains voltage is the same as the operating voltage indicated on the rating plate.
Connect the power plug to the coupling of an appropriate extension cord. Form a loop
push it through the opening in the rear handle and hook over the cable holder (7).
Mounting the hand guard push the supplied hand guard (2) over the blades and fix
securely with each screws (8) on both sides of the housing as showed in drawings.
Starting the machine
Warning! Only use this machine for applications described in the chapter ‘application
range’
Switching on / off
Switching on: Press the on/off switch ( 5 ) of the rear handle and the switch ( 3 ) of the
front handle with both hands at the same time.
Switching off: release one of the switch ( 5 ) or ( 3 ).
Cutting hedges
Before you start your work, select branches with a diameter bigger than 20mm and
cut them with a pruning shear.
16/ 30