Sleep Mode:
Touch the sleep button, the button lights up and start the sleep function.
After no operation in 10 seconds, all indicators turn dark gradually and the wind speed is
automatically switched from high to low, press any button to wake up the indicator. Touch
sleep button again to exit the sleep mode.
Timer button
Touch the timer button to set the 00-24 hour timing function. Display panel ”88 "flashes
and will show timer hour, Touch HUM button, the value increase 1 hour, the value
displayed on the “88” display screen.
In the running state, use the timer function to turn off the machine regularly".
In the standby state, use the timer function to turn on the machine regularly".
Set the time to "00" to cancel the timing function.
Speed
High wind - low wind cycle, Touch the button once to switch and then the corresponding
indicator lights up. In continuously drying mode, sleep mode and defrosting period, the
wind speed can not be changed.
Child lock
Long press the child lock button to turn on or off the child lock function.
Water Tank Full Alarm
Water Tank Indicator
When the tank is full for 5 seconds, it sets the alarm. The water tank indicator turns red
and the unit buzzes for 5 times.
Clear the alarm
When the buzz is on, touch any button to stop it. The compressor, fan shut down and all
the functions freeze until the tank is emptied and back in right position.
5.2 DRAINAGE
There are two ways of removal collected water produced by the unit.
A. Manual draining: Empty water tank by manual.
B. Continuous draining: Use gravity to drain condensate water by attaching a drain hose.
5.2.1 EMPTYING THE WATER TANK
The water tank built in unit, will fill up and shut the unit down once it is full. It will run again
once you empty the water tank and installed properly.
When the tank is full, The unit will make a buzzing sound, and the “Water Full” light
will turn on.
Touch the POWER button to turn off the unit.
Pull on the water tank and simply slide out of the body of the dehumidifier.
Empty the water into an area with a drain or outside.
Clean the inside of the tank as well as the outside.
Replace the empty tank back into the unit.
Press the POWER button to resume operating.
If the Water Full light does not extinguish, check that the float is correctly in place.
25/ 44
