Unpacking and wall mounting instructions
Unpack your package and find the heater together with the wall mounting accessories
pack.
1.
Mark the positions of the four holes to be drilled on the wall, and Drill the holes with the
drill bit
(picture 1).
Make sure the distance between each holes is same as the round holes
on the brackets at back of the heater.
2.
Insert the plastic rails fitting into the h
oles (picture 2).
3.
Insert the metal screws into the plastic rails (picture 3).
4.
Lift the heater and aim the four round holes on the brackets at back of the heater to the
4 screws on the wall (picture 4), and slide the screw from Position A to Position B by
moving the heater slightly (picture 5).
5.
Make sure the distance between the bottom of the heater and the floor is no less than
20cm when the heater is installed
9/12
