MegaPod User Instruction Manual
MaltaDynamics.com | 800-494-1840
2
Please read and understand the manufacturer’s instructions for each component
or part of the complete system. Manufacturer’s instructions must be followed for
proper use, care, and maintenance of this product. These instructions must be
retained and be kept available for the worker’s reference at all times. Alterations
or misuse of this product, or failure to follow instructions, may result in serious
injury or death.
NOTE:
The user is advised to keep the user instructions documents for the life of
the product.
This manual must be read and understood in its entirety and used as part of
fall protection training program as required by OSHA or any stateregularity
agency. These instructions are intended to meet the manufacturer instructions
as required by ANSI Z 359.4-2013 The user mustfully understand the proper
equipment use and limitations.
1. GENERAL REQUIREMENTS, WARNINGS AND LIMITATIONS:
• The Equipment is designed for use as a part of a personal fall protection
system. Components must not be used for any other operation other than that
which it has been designed and approved. Fall Arrest system are designed
to comply with OSHA. Fall Restraint System must be designed by a Qualified
Person, and must be installed and used under the supervision of a competent
person.
• All authorized persons/users must refer the regulations governing occupational
safety, as well as applicable ANSI or CSA standards. Please refer to product
labeling for information on specific OSHA regulations, and ANSI and CSA
standards met by product.
• Consult a doctor if there is any reason to doubt a user’s ability to withstand
and safely absorb fall arrest forces. Age, fitness, health conditions can seriously
affect the worker a fall occur. Pregnant Women and minors should not use this
equipment.
• Proper precautions should always be taken to remove any obstructions, debris,
material, or other recognized hazards from the work area that could cause
injuries or interfere with the operation of the system. All equipment must be
inspected before each use according to the manufacturer’s instructions. All
equipment should be inspected by a qualified person on a regular basis.
• To minimize the potential for accidental disengagement, a competent person
must ensure system compatibility.
• Equipment must not be altered in any way. Repairs must be performed
only by the Manufacturer, or persons or entities authorized in writing by the
manufacturer.
