17
UNpACKING
Carefully remove the product and any accessories from the box. Make sure that all items
listed in the packing list are included.
A) Drill
B) Battery
C) Charger
D) Manual
USING YOUR DRILL
TWO SPEED CONTROLLED SWITCH
Your tool is equipped with two speed controlled switch. The tool speed can be controlled
from speed 0-400 to speed 0-1500 rpm by the pressure you apply to the speed controlled
switch.
FORWARD/REVERSING HANDSPIKE & SWITCH
Your tool is equipped with a forward/ reversing handspike and switch located above the
switch. This handspike was designed for changing rotation of the chuck, and for locking
the switch in an “Off” position to help prevent accidental starts and accidental battery
discharge. for forward rotation, (with chuck pointed away from you) move the handspike
to the far left. for reverse rotation move the handspike to the far right. To activate switch
lock move handspike to the centre “off” position.
MOUNTING AND DISMOUNTING THE BIT
Mounting the bit
Loosen the sleeve by turning it toward the left (in the counterclockwise direction as
viewed from the front) to open the clip on the keyless chuck. After inserting a driver bit,
etc., into the keyless drill chuck, tighten the sleeve by turning it toward the right (in the
clockwise direction as viewed from the front).
NOTE: If the sleeve becomes loose during operation, tighten it further.
The tightening force becomes stronger when the sleeve is tightened.
NOTE! Please read through the manual carefully before
using the appliance and keep it for future reference.
