Imperial Carousel - Page 2
Glass Installation
Wear eye protection during the assembly of
this unit. Check all glass and parts for dam-
age. Replace any damaged parts prior to
continuing the installation. Do not assemble
this unit with any damaged parts. If you
should happen to break a glass panel, it must
only be replaced with ceramic glass.
1. The door panel has had the latch assembly
and hinges installed at the factory. Remove
the hinges leaving the glued on plate in posi-
tion.
2. Place the lower hinge in the hole in the firebowl,
with the washer under it.
3. Insert the upper hinge into the hole at the top
of the door opening. Holding the upper hinge
in place, slide the glass door panel into the
hinges.
4. Hold the door panel in the closed position to
allow access to the hinge screws.
5. Maintaining a 1/8" clearance to the left door
post, tighten the screws in the hinges snugly.
DO NOT OVER TIGHTEN
. Re-adjust as
necessary for proper alignment.
6. Note that two panels have gasket material on
one edge. These pieces go on either side of
the door. Make certain that these two pieces
are placed completly into the channel on
either side of the door. Failure to do this will
make the rest of the glass installation impos-
sible.
7. First loosen the glass retainers. This is a
metal strip secured by one screw in the
middle. Start with the left door panel. The
gasket must be on the right side of the panel.
8. Slide the gasketed edge completely into the
channel on the side of the door. The left edge of
the glass should now fit into the button at the
bottom of the glass.
9. Lower the glass into the lower glass button
channel.
10. Repeat steps 8 and 9 with the right door panel.
The gasket will be on the left side of the panel
with the not polished edge at the top.
11. The remaining panels can now be installed.
The edge that is not polished is placed at the
top. As each panel is installed replace the
glass retainer in place but do not tighten.
12. After all the glass panels are installed center the
panels to reduce any gaps that may be be-
tween the glass panels.
13. Tighten the glass retainers.
Hood
Retainer
and Screw
Glass
Lower Glass
Button
Upper
Glass
Channel
