Malloca MR 593, Instruction Manual

Page: 7 / 16

7
Select the zone to be switched off using the corresponding button (5). The display (6) of the zone
selected lights up, while the remaining displays are dimmed. Press the PLUS
(3) and MINUS (2) buttons at the same time and the setting level of the zone is changed to 0.
Alternatively, the MINUS button (2) can be used to reduce the setting level to 0.
If a cooking zone is “hot”, “H” and “0” will be alternately displayed.
Switching-OFF all cooking zones
Pressing the ON/OFF (1) button at any time will cause all cooking zones to switch off immediately.
In the standby-mode an “H” appears on all cooking zones which are “hot”. All other cooking zone
displays are not illuminated.
Setting level
The cooking zone can be set to 9 levels that are indicated by the numbers “1” to “9” on the seven-
segment LED display.
Residual heat indicator
It is meant to indicate to the user that the glass ceramic has a dangerous touch temperature in the
circumference of a cooking zone. The temperature will be determined following a mathematical
model and the remaining residual heat will be indicated by means of “H” on the corresponding
display.
Heating-up and cooling down will be calculated dependent on:
-
The selected setting („0“ to „9“)
-
The ON/OFF time.
After switching-OFF the cooking zone the respective display shows “H” until the assigned cooking
zone temperature is mathematically in a uncritical level (<60°C).
Automatic power OFF function (operating time limitation)
Dependent on the selected setting, every cooking zone will be switched-OFF after a defined
maximum operation time if no operation of the assigned cooking zone follows within this time
period. Every change of the cooking zone condition (by means of the PLUS+, MINUS-, or dual zone)
puts back the maximum operation time of this cooking zone to the initial value of the operating time
limitation.
Protection against unintended switching-ON
If the electronic control realizes a continuous operation of keys for approx. 10 seconds, it switches
OFF automatically.
The control sends out an audible error signal to warn the user that the sensors have detected the
presence of an object. The displays indicate error code “ER03”. If the cooking zone is in “hot” mode,
“H” will be indicated alternately on the display with the error signal.
If no cooking zone is activated within 20 seconds of switching on the touch control, this will revert
to stand-by status.
When the control is switched- ON the ON/OFF key has priority over all other keys, so that the
control can be switched-OFF anytime, even in case of multiple or continuous operation of keys.
In the stand-by mode a continous operation will not be signalized. However, before the electronic
control can be switched ON again, it has to recognize that all keys are not operated.
Button lock (child safety feature)
Child safety feature:
Button lock:
To activate the child safety feature after having switched on the Touch control, press the left
cooking zone selection but- ton at the same time as the MINUS button (2) for 3 seconds, followed by
just the left cooking zone selection button. An “L” standing for LOCKED (child safety feature
preventing unintended switch on) will be indicated on all displays. If a cooking zone is in “hot” mode,
“L” and “H” will be alterna- tely displayed.
This operation must take place within a 10 successive se- conds and no button other than those
described must be pressed. Otherwise, the sequence will be interrupted and the hob will not be