Malloca MIR 593, Instruction Manual

Page: 9 / 20

9
Cài đặt thời gian
Protection against unintended switching-ON
The electronic system cuts off automatically in case of an identified permanent use of keys for
about 10 seconds. The control unit releases an audible signal for 10 seconds of the malfunction and
the error code “ER03” flashes on the display (0.5s ON, 0.5s OFF). If the permanent actuation exceeds
10 sec, alone the error code “ER03” keeps flashing as long as the malfunction occurs and is identified
as such. In case th cooking zone is at stage “hot” the [H] symbol altenates with error code.
Water sprinkled on the glass surface does not always lead to a key actuation and cannot be surely
detected.
If no cooking zone is activated within 20 sec after pressing POWER ON, the control unit is reset to
OFF mode (black displays).
Key lock
The actuation of the key lock key (4) in the wait or active mode locks the keyboard and the
assigned key-lock LED “7” is statically illuminated. Here, the actuation times of the key lock have to
be taken into account. The control continues to work in the set mode, but may no longer be operated
with any key, expect the key-lock key itself or the on/0ff key (1).
The switching off with the on/off key “1” is also possible in the locked condition. The assigned
key-lock LED “7” fades when switching off the control the key-lock function
Control of multiple circuits
When a dual/ triple cooking zone is activated, the 3 circuits are switched on at the same time. The
activation / deactivation of each circuit is done with button 4 and it is indicated with an illuminated
segment.
Sound signal (buzzer)
The following activities occurring during operation of the touch control unit are feedback audibly
via a buzzer :
-
Short single tone for regular actuation of a key
-
Longer, intermittent tone for permanent use of keys over a longer period of time (> 10 sec).
-
Expiry of the timer
Maintenance
Any remains of aluminium foil, food, fat, sugar or food with high sugar content must be
immediately removed from the hob surface to prevent potential damage to the hob surface.
Subsequently clean the surface with some towel and appropriate product, rinse with water and dry
by means of a clean cloth. Under no circumstance should sponges or abrasive cloths be used; also
avoid using aggressive chemical detergents such as oven sprays and spot removers.
Timer function
The timer function is available in two types:
-
Stand-alone-timer 1..99 min: This function can only be activated as long as no cooking zone is in
operation (all stages = 0). If the timer shall be used to cut off a cooking zone (see cooking zone
timer) then the control must first be switched off power sensor and switched on again.
-
Cooking zone timer 1..99 min: This function can only be activated as long as a cooking is active
(stage > 0; display dot).
Setting a timer value :
By adjustment with the slider area. Primarily the adjustment of the first digit takes place and there
after the adjustment of the second digit.
In case of an active timer display the timer value may be set to [0] directly by pressing [0] on the
slider area (left side).
Switching off an active timer:
A timer can be switched of by setting its value to “0”.
A stand alone timer can be switched of by a double actuation of the power key “1”.
Timer Stand-alone:
If the control unit is switched on (all cooking zone displays show “0”), the stand-alone timer