the lower part
.
-
Please attention that the arrow is positioned on the same side as the
appliance controls. Make 4, Ø8 holes in the ceiling and drive in 3 screws
without completely tightening them(Fig2). Pay attention not to insert the
screw into the hole marked with an
X
on the hole template (the screws and
expansion plugs must be suitable for the type of wall).
- Take the upper part of the structure
B
and insert the 3 slots onto the 3
screws that are not completely tightened. (Fig3)
Rotate slightly to fit.
Drive in the fourth screw
X
and tighten the remaining 3 to allow definitive
blocking of the upper part of structure
B.
-
Take the lower part of the telescopic structure
C
and insert it into the
upper structure
B
.
-
Adjust the height (Fig.5) by referring to the amounts indicated in and
block it using the 8 unit screws
G
that are supplied (Fig.4)
-
Suction
version:
fix the flexible pipe to the prepared air evacuation hole
(Fig.6).
-
Take the upper chimney piece and fix it with 4 unit screws G.
（
Fig.7
）
-
Take the lower chimney and fix it with 2 unit screws G, drive in hood to
avoid it down .
（
Fig.8
）
-
Insert the suction unit inside the structure and set in 4 mounting hole,
drive in 4 unit screw N (Fig.9).
-
Fix the air evacuation pipe
H
(not supplied) onto the connection flange
(Fig.10)
-
Unscrew the 2 screws
G
.and rest the lower chimney piece above the
cooker hood (Fig.11).
