Malloca K1153, User Manual

Page: 19 / 27

10 ASSEMBLY OF PRODUCT
1.
For the 60 cm model; drill with Ø3 mm drill at locations speci-
fied on the installation schematic with A, B, C and D on the
surface where the product is to be installed. For the 90 cm
model; drill with Ø3 mm drill at locations specified on the
installation schematic with A, B, C, D, E and F.
2.
Before placing the cooker hood in the cabinet, screw the
plastic flue (Fig. 11).
Motors with circular air exhaust do not have
this part.
3.
Mount one end of the aluminium pipe to the air outlet of the
product. Mount the other end of the aluminium pipe to the
kitchen flue, make sure that both connections are tight
enough to avoid removal during operation of the cooker hood
at the highest speed (Fig. 12).
Since twists and bends in the aluminium pipe
will lead to reduction in the air suction power,
avoid using twists and bends as much as
possible.
4.
Place the cooker hood inside the cabinet. Fix the product by
aligning the holes drilled according to the mounting draft and
holes on the product panel (Fig. 13).
Drilling the Hanger Holes
Fig. 11
Fig. 12
1
Fig. 13
1- Hanger Holes
ASSEMBLY OF PRODUCT
16.10.2018 HOOD USER GUIDE ENGLISH 19