5
Fault Finding
●
Alarm does not sound:
Switch on the receiver (Rx). Red LED light will flash.
Replace batteries with new Alkaline ones (2 x AA). Observe correct
battery orientation and make sure contacts inside the alarm are clean
and free of any deposits.
Does the transmitter red LED glow when the
Easy-Clip©
lever
is
lowered? If not, replace battery (Alkaline 23AE 12v) observe
correct polarity and clean contacts.
If all the above fail, re-tune Rx and Tx, see pages 4 and 9.
●
Alarm does not reset:
Clean
Easy-Clip©
sensor by lifting lever, wash in soapy water, rinse
under the tap and shake dry.
Make sure
Easy-Clip©
lever is up.
Make sure that underpantsʼ material is not too thin or wet.
Replace receiver batteries (2 x AA Alkaline).
Transmitter is damaged or flooded.
●
Sound level is too low:
Adjust sound level with volume control.
Guarantee
Under normal use the Malem Wireless Alarm is guaranteed for a period of
three months from purchase. This excludes batteries, flooding, misuse,
physical or accidental damage. If the alarm should malfunction during this
period, please contact us BEFORE RETURNING. Please remove batteries
and decontaminate the unit/sensor before returning. DO NOT return
flooded or contaminated alarms.
Repairs
If your alarm requires repair, we will exchange it for a new one at a special
discount. (Repairs are not undertaken for hygiene reasons). Please contact
us by telephone, fax, e-mail or in writing for the cost of this service. Please
decontaminate the unit before returning.
