2
Malem Enuresis Wireless Alarm
Instructions: Please read
1.
Select a pair of close fitting cotton underpants.
2.
Attach the small transmitter (Tx) to the
outside
of the underpants
waistband using the magnetic clip. See page 12.
3.
Lift the
Easy-Clip©
lever, remove and dispose of the white plastic
insulator (if present). Keep lever up.
4.
Attach the
Easy-Clip©
sensor
to the
outside
of the underpantsʼ, at
the location most likely to get wet first (boy or girl), by folding and
inserting the material inside the sensor jaws at the front. Lower the
lever to lock onto the material. See diagram below.
5.
Switch on the receiver (Rx). Red LED will flash.
6.
Place the receiver away from the bed but in the
same room
if treating
Enuresis (bedwetting).
7.
Upon waking to the alarm sound, remove the
Easy-Clip©
sensor by
lifting the lever. Stop the alarm sound by pressing the reset button on
the top of the receiver. Do not switch off the receiver. Use the lavatory
to completely empty the bladder.
8.
Replace the transmitter and the
Easy-Clip©
sensor onto a clean and
dry pair of underpants as before.
Lock the Easy-Clip
onto the material by
pressing down the lever.
IMPORTANT:
Regularly CLEAN Easy-Clip
Sensor in soapy water, rinse
and shake dry.
IMPORTANT: DO NOT PLACE
ANY MATERIAL UNDER THE
SECURING LEVER.
Place underwear material into mouth
(jaws) at the front of the Easy-Clip .
