26 XAM
ENG
Insufficient mileage from a
single battery charge.
The tyre pressure is
insufficient
Make sure that the tyre pressure
is correct.
The battery is not fully
charged or the charger is
defective.
Fully charge the battery or
check that the charger plug is
connected correctly.
The brake setting is not
correct, the driving resistance
is too high.
Readjust the brake system
The battery is aged or
damaged
Change the battery
Too many gradients,
headwind, frequent
acceleration and braking,
heavy load
It is normal for the mileage to
decrease in this circumstance
The charger does not work
Two lights flash
Undervoltage of the battery
(lower than 44 V) or short
circuit at the output
Restore the voltage above 56 V
or replace the battery.
Three lights flash
Overvoltage of the battery
(higher than 85 V)
Reduce the voltage to less than
84 V or replace the battery.
Four lights flash
The positive and negative
terminals of the battery are
connected back or the battery
is overheated.
Check the connector plug and
wait until the temperature of the
battery has dropped below the
limit value
Five lights flashing
Fault in the charger
Wait until the charger
temperature is below the limit or
replace the charger.
The charger plug falls off or
the connection is loose
Check that the charger input
and output plugs are correctly
connected
Noise from the plastic body
when driving
The tightness of the chain is
not adequate
Adjust the tightness of the chain
Other fault
If you encounter a fault that
cannot be rectified according
to the above instructions,
or a fault that cannot be
determined.
In such cases, please contact a
workshop. The above-mentioned
parts must not be opened You
must not use the appliance
without authorisation, otherwise
you will lose the company's
guarantee promise
Damage to the motor,
controller, charger and battery
pack.
FAULT DETECTION
