A
6
09.03
INTRODUCTION
CHAPTER
PAGE
ISSUE
CHASSIS
ENGLISH
SECTION 1
A
- CHASSIS
F
Figure
Cs
Tightening torque
P
Page
Pr
Paragraph
S
Section
Sc
Diagram
T
Table
V
Screw
EDITING SYMBOLS
• Symbols have been provided for
quick and easy reference (see page 9), identifying situations requiring
utmost attention or providing practical suggestions or simple information.
•
These symbols
may appear
next to a text
(in which case they refer solely to the text itself),
next to a figure
(in which case they refer to the topic illustrated in the figure and to the relative text), or
at the top of the page
(in which case they refer to all the topics dealt with in the page).
Note:
The meaning of the symbols should be duly memorised as their scope is to avoid having to repeat basic technical
concepts or safety recommendations. They are therefore to be considered as veritable “
memory tags
”.
In case of
any doubt as to their meaning, consult the page in which they are fully described.
ABBREVIATIONS
Note:
the letter V in the illustrations refers to retaining or adjusting
screws.
The
number
following this letter refers to the
number of the same type of screw in the unit or component described and illustrated. Letters
not followed by a
number
indicate
a single screw
. In case of
different screws
being referred to in the illustration, the letter
V
is
followed by a
number
and a
small letter.
For instance:
(V4a).
Unless otherwise specified, units and components are reassembled by proceeding in the
reverse order
of remov-
al.
GENERAL WORK PROCEDURES
• The
advice
,
recommendations
and
warnings
given hereafter are aimed at ensuring maximum work safety as
well as at considerably reducing the risk of accidents, personal injury, equipment damage and idle times. They
should therefore be strictly adhered to.
