B
24
10.05
CHAPTER
PAGE
ISSUE
ELECTRIC SYSTEM TROUBLESHOOTING
ENGLISH
SECTION 2
Light system
SECTION 2
B
- TROUBLESHOOTING
1.2 Checking voltage level.
- Detach cables from headlight and connect
Tester (AC 20
V)
as follows:
- Terminal (+) of Tester
White/black cable (1).
- Terminal (-) of Tester
Black cable (2).
- Run engine at approx. 2000 RPM.
- Flick light switch to (
) symbol.
- Flick light switch to (HI) symbol.
-
Value read must be approximately 12 Volts.
2
1
NOT COMPLIANT
- White/black cable between left hand switch and headli-
ght connector is interrupted.
- Repair.
- See “Wiring Diagram”.
2. HIGH BEAM INDICATOR LIGHT DOES NOT COME ON.
2.1 Check voltage level.
- Connect
Tester (AC 20 V)
to instrument board connector
as follows:
-
Terminal
(+)
of
Tester
White/black
cable
(1).
- Terminal (-) of Tester
Black cable
(2).
- Run engine at approx. 2000 RPM.
- Flick light switch to (
) symbol.
- Flick light switch to (HI) symbol.
-
Value read must be approximately 12 Volts.
1
2
NOT COMPLIANT
COMPLIANT
- System is working.
- Check lamp and lamp socket of instrument board; if
necessary, replace faulty part.
CHECKING LIGHT SYSTEM
1. HIGH BEAM LIGHT DOES NOT COME ON.
1.1 Check lamp and lamp socket.
- See the “Checking switches” section (on page 12).
NO CONTINUITY
- Replace lamp and/or lamp socket.
CONTINUITY
B/N
N
- White/black cable between left hand
switch, headlight and instrument
board connector is interrupted.
- Repair.
- See “Wiring Diagram”.
