Manual for
RV 100 Ah
battery
Product Manual RV Battery
NO. : HC20-PKLI20011
REV
：
R1.1
6
Distributor: Bruenech AS
e-mail: [email protected]
when the current is greater than or equal to 5 A, if the ambient temperature is less than
0
℃
, the BMS will send a heating signal, and the external power supply of the heating film
will be turned on, at this time, the charging MOS will be cut off, Charging is not allowed.
When the temperature is
≥
0
℃
, the MOS of BMS is closed and the battery is allowed to
charge; when the temperature reaches 10
℃
, stop heating and continue charging!
7 Extra Tips
You encounter difficulties, please contact us, we will try our best to provide you with
service and help.
➢
Please do not be machined on the circuit board, any damage may cause functional
failure of the internal circuit;
➢
Please do not make the force and deformation to the product, any damage to
electronic components or lines may make the product unstable.
➢
Please do not disassemble the shell, lest you cause unnecessary damage to you;
➢
The charging terminal polarity is reversed, and it burn internal circuit board, please
pay attention to the port when connect.
8 Tests
Single cell and Protection Circuit Specification are only results of standard test, this is
8.1 Standard Test
Requirements
Battery test must be within 1 month after production. All tests in this specification should
be at standard atmospheric conditions. (Temperature: 25± 2
℃
, relative humidity: 65±
20%).Charge voltage is
14.6±0.05
V, Standard cutoff voltage is about
10
V; Standard
current is I
5
(A).
8.2 Standard Charge
Charge the battery with Lithium ion battery special test cabinet, supply standard voltage,
standard current until current down to 0.05I
5
(A).
