8
11. Assemble the side table according to the following
steps:
- Remove the Allen screw 1/4 '’x 28 mm (A) to insert the
table (B) in the correct position;
- At the rear of the machine, insert the screw
located on the part (A) in the hole of the support part (B) and
lock with the butterfly nut (C).
- Retighten the Allen screw, which was
previously removed, on the side table.
12. Install the Side Guide (A) on the table (B) and fix it
through the quick-release handle (C), turning it
down. Look the following picture
13. Install the Half Moon Guide (A) in the channel (B)
located
at the top of the table, to make straight cuts or
angled, as shown in the following figure.
14. Install the tape tension adjustment handle (A)
placing it in such a way as to involve the screw that is
located on the top of the machine. See figure as follow.
15 Install the special Slotted screw and washer
(A) on the left side of the machine, so that it serves
support for the push stick (B) that comes with
this equipment. This stick is indispensable for the
cutting small parts. Look the following picture.
