10
press, a mold or any other element to prevent
movement during cutting.
Arched Material
When cutting a material that is arched, position it with
the hollow facing the front of the equipment, and never
facing the side guides. The incorrect position of the
material may cause it to tighten the disc before
finalizing the cut.
Cutting of Plastic Tubing and Other Circular
Cross-Cutting Materials
The plastic tubing can be easily cut with your saw, just
like cutting wood. For this, the material must fit firmly
against the guide in order to prevent its movement,
particularly when making angular cuts.
1. All fixed parts of the saw are sealed. They are
permanently lubricated and require no
maintenance.
2. Clean and remove all dust and wood chips from the
surroundings and under the base and rotary table
periodically. Even if there are consoles to allow that
waste to drain, there will be the accumulation of
dust.
3. The bushings are designed to provide several years
of use.
Important: To maintain security and reliability
of the product, repairs, maintenance and adjustments
should only be carried out by authorized technical
assistance that will use identical parts for replacement.
Frequent Troubleshooting Guide Be sure to follow the
safety rules and instructions according to the table
below.
CAUTION:
The use of any accessory not
recommended as a
set
for cutting channels,
cutting frames or discs
abrasives, can be dangerous.
TECHNICAL ASSISTANCE
For your greater safety, entrust repairs, maintenance
and adjustments (including inspection and
replacement) to the technical assistance
recommended by MAKSIWA, which will always use
genuine spare parts and accessories, reassembling
your saw in the same way as the original.
The use of this tool for professional or industrial
purposes is not recommended by MAKSIWA. Before
using an extension cord, check for loose or exposed
wires, damaged insulation and defective fittings.
Repair or replace the extension if necessary.
Imported by Maksiwa USA Inc.
4100 N Powerline Rd, Suite D3
Pompano Beach, FL 33073
www.maksiwa.com
754-205-6717
MAINTENANCE
PROBLEM
ISSUE
HOW TO FIX
The saw does not start.
Saw is not connected
.
Connect the saw
A fuse might be burned
.
Change the fuse.
The switch is open.
Close the switch.
The wire is damaged
.
Replace the wire at an authorized shop.
Coals have worn out
.
Replace the coals at an authorized workshop.
The saw does not
make satisfactory
cuts.
The disc isn't sharp
.
Exchange the disc
The disc is mounted upside down.
Switch the position of the disc.
The disc is
dirty.
Remove the disc and clean it.
Incorrect disc for the type of fob
.
Switch for the correct disc.
Piece is not fixed correctly
.
Fix the part properly to your saw.
A escala de ângulos não está ajustada.
Check and adjust the scale.
The angle scale is not adjusted
.
Check and adjust.
O disco não está perpendicular à mesa.
Check and adjust according to the instructions.
The disc is not perpendicular to the table.
Fit the workpiece to the guide.
The disc does not
reach working speed.
Extension cable too thin or too wide.
Replace with a suitable extension.
Dirt preventing movement of the disc.
Remove the disc and clean it.
The electric current is too low (oscillating).
Check with your power supplier for any issues.
The machine vibrates
excessively.
Saw incorrectly attached to the table.
Check the assembly instructions.
The table or bench with uneven surface.
Place the saw on a suitable surface.
The saw blade is damaged.
Replace the disc.
O material danifica o
disco.
Is cutting arched material
.
Place the part according to the instructions.
Material in disagreement with the instructed.
See instructions for materials.
