8
1. Rubber Adjustment Feet
2. Cast Iron Structure
3. Angle Guide
4. Table Tilt Lever
5.
On/Off Button
6. Motor
7. Quick Stop Lever
8. Disc Sanding (12’’ or 300mm)
9. Support Table
3 Installation
For packaging reasons, the machine is not completely assembled.
If you notice any damage caused by transportation while opening the package, notify your supplier
immediately. Do not operate the machine.
Dispose of the packing in an environmentally friendly manner.
The sander is designed to operate indoors and must be placed on a firm, stable and level surface.
CAUTION: To prevent the machine from moving and causing a lack of precision, make sure that the
base on which it is supported is not uneven. If the machine moves on the surface, place a support
under the base until it is firmly on the surface.
3.1 Unpacking
Due to modern mass production techniques, it is unlikely that the LD.300 MAKSIWA sander is
defective or that a part is missing. If you find something wrong, do not use the tool until the parts
are replaced, or the fault is corrected. By doing this you are avoiding serious bodily injury.
Do not use the sandpaper without the table. Lack of support can result in risks and a lack of precision
in the process.
1. Remove all loose parts from the packaging.
2. Remove the packaging materials around the parts.
3.
Carefully lift the main packaging structure and place it on a flat surface.
4.
The assembly of your sander is quite simple. Start by fixing the table (A) close to the base, using
the two side handles (B), as shown in the following figure.
5. Turn the base over and install the 4 rubber feet (C) in each corner. Place the base in the correct
