20
DETERMINATION OF TARGET DEPTH
6
Maximum value that can be entered for width and length is 160 cm. If measured
values exceed 160 cm, enter 160 cm into the respective field and perform a depth
scan.
7
After entering these values, press and hold the
SCAN button and sweep the coil over the target,
release the SCAN button after the signal disap-
pears.
8
At the end of these processes, a Depth Report
showing the depth and measurement values
entered will be obtained. The value obtained
is an approximate one.
Press the “RECORD” key if you wish to save this
report, a message indicating the saving is
completed will appear on the screen.
Press the OK button or the “Reset” trigger to
exit this report.
The device will return back to the Depth
mode; you can switch to the Search mode by
pressing the DEPTH button.
