Page
13
of
13
parameters E1 and E2
2
–
as in setting 1, but disabling with the
stirrer's working button causes its operation
only during the operation of the unit
3
–
as in setting 1, but the button that disables
the stirrer operation is inactive
4
–
continuous operation, regardless of the
operation of the unit and times set in the
parameters E1 and E2
standstill time of the stirrer
E1
the possibility of setting the time from 1 min.
to 60 min., every 1 min.
15 (min.)
working time of the stirrer
E2
the possibility of setting the time from 1 min.
to 60 min., every 1 min.
2 (min.)
manual stirrer operation
mode
CP
0
–
continuous work
>0
–
stirrer operation for a specified time in the
range of from 1 min. to 60 min., every 1 minute
5 (min.)
delay of registering of the
max. / min. values
of temperature and delay
of activation of the
temperature alarm
AA
the possibility of setting the time from 0 h to
24 h, every 0,1 h
2 (h)
lower temperature of the
alarm
A1
the possibility of setting the temperature from
-40
O
C to +120
O
C, every 1.0
O
C
2 (
O
C)
upper temperature of the
alarm
A2
the possibility of setting the temperature from
-40
O
C to +120
O
C, every 1.0
O
C
12 (
O
C)
sound of the alarm
HE
0
–
on
1
–
off
0
visual and sound alarm
of exceeding the set
temperature range
(parameters A1 and A2)
HA
0
–
on
1
–
off
0
scaling the control sensor**
CU
every 0,2
O
C
scalable
value
setting the operation of the
limit switch of opening the
tank’s flap
UU
0
–
closing the limit switch: raising the flap
1
–
opening the limit switch: raising the flap
0
delay of switching on the unit
and the stirrer after
connecting
the regulator to the mains or
when power supply decay
occurs
dE
from 1 s. to 999 s., every 1 s.
5 (s.)
display status when the
control is switched off
d1
0
–
the dot is displayed
1
–
the currently measured temperature is
displayed
0
return to factory settings
FA
0
1
–
after setting "1" and turning off the
regulator from the power supply, switching on
again restores the factory settings and the
parameter value goes back to "0"
0
leaving the settings
EE
** set at the manufacturing stage (do not change without obvious need)