3. The battery is protected against deep discharging. When the battery is empty, a protective
circuit automatically switches off the tool. Charge the battery when the tool no longer runs.
Electrical Specifications of the Charger:
The 230V 50Hz charger is equipped with double insulation and does not require any earth connection.
It is a hermetically sealed unit equipped with an internal fuse which cannot be replaced.
This charger does not contain any components which can be repaired by the user.
Never remove the charger housing. This appliance contains dangerous voltages. If in doubt, consult a
qualified electrician.
For your own protection, do not expose this charger to rain or damp locations. Do not place it on damp
or wet surfaces and use a workbench as far as possible.
It is recommended that the tool always be supplied via a residual current device with a rated
current of 30mA or less.
This charger is for exclusive use with this appliance and must not be used for any other purpose. Do
not use any other charger to charge these batteries.
Caution: Never use the charger in your house. Always charge the batteries on a bench
in your workshop. Never exceed the charging time specified in the manual.
Disposing of the Battery:
When the battery does not recharge or does not keep its charge, its service life is at an end.
The battery must be disposed of in an environmentally friendly manner. Do not throw it into
the household waste system. Take it to a recycling centre or a specialized disposal centre.
Caution: Do not destroy the battery by burning it; otherwise it poses an explosion risk.
The battery charger must be connected to a voltage equal to that indicated on the rating label. If the
outlet or mains power cable is damaged, replace it with a complete set identical to the original. If you
have any doubt at all, consult an electrician.
MAKO CORDLESS SCREW DRIVER OPERATING INSTRUCTIONS:
This cordless screwdriver accepts screw driver bits of various lengths which have a hexagonal shaft of
6.35 mm.
Inserting the Screw driver Bit :
Select the screw driver bit which is appropriate for the screws used and insert it into the chuck (2),
taking care that it is fully inserted.
Note: it is recommended to always drill a guide hole for the screw before driving.
Switching On and Off:
Press the trigger to drive the screw – release to turn off. The LED Light (3) will turn on and off as the
trigger is pressed and released.
Changing Direction:
With the tool stopped, press the Rotation Direction Switch (5) to the right to drive screws, or to the left
to remove screws.