Makita XSJ01, Instruction Manual

Page: 8 / 40

8
Replacing carbon brushes
1
006258
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First remove the holder by unscrewing the hex socket
head bolt.
1
2
009048
Then loosen the hex socket head bolt that fastens the
barrel and turn the barrel counterclockwise.
1
2
009049
Use a screwdriver to remove two screws then remove
the front cover.
1
2
009023
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
1
2 3
006816
Use pliers to remove the carbon brush caps of the carbon
brushes. Take out the worn carbon brushes, insert the
new ones and replace the carbon brush caps in reverse.
1
006817
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
1
2
006304
Reinstall the front cover and tighten two screws securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Center blade
•
Side blade R
•
Side blade L
1. Hole
2. Carbon brush
cap
1. Carbon brush
cap
1. Spring
2. Arm
3. Recessed part
1. Front cover
2. Screws
1. Barrel
2. Hex socket head
bolt
1. Holder
2. Hex socket head
bolt
1. Limit mark