19 ENGLISH
Cancelling tool registration for the
vacuum cleaner
Perform the following procedure when cancelling the
tool registration for the vacuum cleaner.
1.
Install the batteries to the vacuum cleaner and the
tool.
2.
Set the stand-by switch on the vacuum cleaner to
"AUTO".
1
►
1.
Stand-by switch
3.
Press the wireless activation button on the vac-
uum cleaner for 6 seconds. The wireless activation
lamp blinks in green and then become red. After that,
press the wireless activation button on the tool in the
same way.
1
2
1
2
►
1.
Wireless activation button
2.
Wireless activation
lamp
If the cancellation is performed successfully, the wire-
less activation lamps will light up in red for 2 seconds
and start blinking in blue.
NOTE:
The wireless activation lamps finish blinking
in red after 20 seconds elapsed. Finish pressing
the wireless activation button on the tool while the
wireless activation lamp on the vacuum cleaner is
blinking. If the wireless activation lamp does not blink
in red, push the wireless activation button briefly and
hold it down again.
Summary of Contents for XPS02
Page 47: ...47 ...
