10 ENGLISH
Application mode
(Impact force grade
displayed on panel)
Maximum blows
Purpose
Example of application
T mode *
–
(The tool stops rotating
soon after impact starts.)
Driving self-drilling screws to a thin
metal plate with good finish.
Tightening self-drilling screws.
: The lamp is on.
*
When the tool rotates counterclockwise, the impact per minute is the same as in 4 (max) mode, 4,100 min
-1
(/min).
NOTE:
When using T mode, the timing to stop the driving varies depending on the type of the screw and material
to be driven. Make a test driving before using this mode.
NOTE:
When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button or
button .
NOTE:
All lamps on the switch panel go out when the tool is turned off to save the battery power. The impact force
grade can be checked by pulling the switch trigger to the extent that the tool does not operate.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
Use only the driver bit/socket bit shown in the figure. Do
not use any other driver bit/socket bit.
12 mm
(15/32”)
9 mm
(3/8”)
Fig.9
To install the driver bit, insert it into the sleeve as far as it will go.
1
2
Fig.10
►
1.
Driver bit
2.
Sleeve
To remove the driver bit, pull the sleeve in the direction
of the arrow and pull the driver bit out.
1
2
Fig.11
►
1.
Driver bit
2.
Sleeve
NOTE:
If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc
-
tions above.
NOTE:
When it is difficult to insert the driver bit, pull
the sleeve and insert it into the sleeve as far as it will
go.
NOTE:
After inserting the driver bit, make sure that it
is firmly secured. If it comes out, do not use it.
