11 ENGLISH
For depressed center wheel, flap
disc, wire wheel brush / abrasive cut-
off wheel, diamond wheel
1.
While pushing the lock lever, mount the wheel
guard with the protrusions on the wheel guard aligned
with the notches on the bearing box.
3
2
1
►
1.
Lock lever
2.
Notch
3.
Protrusion
2.
While pushing the lock lever toward A, push in the
wheel guard by holding down the portions B as shown
in the figure.
2
B
1
A
B
►
1.
Wheel guard
2.
Hole
NOTE:
Push down the wheel guard straight. Otherwise,
you cannot push the wheel guard completely.
3.
While keeping the lock lever and wheel guard position as
described in step 2, rotate the wheel guard toward C, and then,
change the angle of the wheel guard according to the work.
2
B
1
A
B
B
C
C
►
1.
Wheel guard
2.
Hole
NOTE:
Push the wheel guard completely. Otherwise,
you cannot rotate the wheel guard.
To remove wheel guard, follow the installation proce-
dure in reverse.
When using a depressed center
wheel or flap disc
Optional accessory
WARNING:
When using a depressed center
wheel or a flap disc, the wheel guard must be
fitted on the tool so that the closed side of the
guard always points toward the operator.
1
2
►
1.
Depressed center wheel
2.
Wheel guard
