Makita TW004G, Instruction Manual

Page: 4 / 96

4 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model: TW004G TW005G
Fastening capacities Standard bolt M10 - M20
High tensile bolt M10 - M16
Square drive 12.7 mm
No load speed (RPM) Max impact mode 0 - 3,200 min -1
Hard impact mode 0 - 2,600 min
-1
Medium impact mode 0 - 1,800 min
-1
Soft impact mode 0 - 1,000 min
-1
Impacts per minute Max impact mode 0 - 4,000 min -1
Hard impact mode 0 - 3,400 min
-1
Medium impact mode 0 - 2,600 min
-1
Soft impact mode 0 - 1,800 min
-1
Overall length 144 mm
Rated voltage D.C. 36 V - 40 V max
Net weight 1.9 - 2.2 kg
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi -
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge BL4025 / BL4040
Charger DC40RA
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined accord -
ing to EN62841-2-2:
Model TW004G
Sound pressure level (L
pA
) : 99 dB(A)
Sound power level (L
WA
) : 110 dB (A)
Uncertainty (K) : 3 dB(A)
Model TW005G
Sound pressure level (L
pA
) : 99 dB(A)
Sound power level (L
WA
) : 110 dB (A)
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-2:
Model TW004G
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (a
h
) : 16.5 m/s
2
Uncertainty (K) : 1.5 m/s
2