4
contracted, or it will be damaged.
Before rotating unit, make sure the all of the level
adjusting legs are fully extended and fastened with the
level adjusting rings.
Attaching and replacing batteries (Fig.2)
Fig. 2
Makita SK20 exclusive
uses Elevating Tripod.
Fig. 3
OPERATION
Fig. 4
1. Turn on the power switch (12). The unit (laser
level) projects the horizontal laser- beam line.
2.
If the unit is placed in a slanting position, it will not
emit any laser lines at all. Adjust the level
adjusting ring (9) so that the air-bubble in the
round vial (4) is centered. (See the Fig. 4)
3.
If you work with the receiver (optional accessory),
press the interior/exterior mode change button (2).
Exterior mode indicator LED (green) (3) will light
on.
Following 3 operation modes are available. Press
the most suitable operating-mode selecting button
(1) according to your job.
Horizontal
Fig. 5
Press the H button. The unit projects the horizontal
laser-beam line as illustrated in Fig.5.
You can adjust the height of the horizontal laser
line by mounting the unit to Elevating tripod
provided
(See the Fig. 3)
Ve Right angle (Vertical) + Plumb Point (floor)
Fig. 6
Press the 2V button. The unit projects the vertical
laser-beam lines as illustrated in Fig.6.
Ve Right angle (Vertical) + Hori Plumb
Point (floor)
Fig. 7
Press the 2V/H button. The unit projects the
laser-beam lines (2 vertical and horizontal ones) as
illustrated in Fig.7.
4.
Turn off the power switch after operation. The unit
will be automatically locked.