Makita RP2301FCX, Instruction Manual

Page: 14 / 82

12
Fig.27
Fig.28
Fig.29
At this time, apply some grease or lubricating oil to the
inside of the screw hole in the tool base and the threaded
part in the motor bracket.
Fig.30
Fig.31
2. Adjusting the depth of cut
•
A small amount of depth of cut can be obtained by
turning this screw with a screwdriver from above
the table. (1.0 mm per a full turn)
•
Turning it clockwise makes the depth of cut greater
and turning it counterclockwise smaller.
Fig.32
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
•
Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
Fig.33
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
Fig.34
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 minutes.
Then check the tool while running and electric brake
operation when releasing the switch trigger. If electric
brake is not working well, ask your local Makita service
center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL ACCESSORIES
CAUTION:
•
These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
•
Straight & groove forming bits
•
Edge forming bits
•
Laminate trimming bits
•
Straight guide
•
Trimmer guide
•
Guide holder
•
Templet guides
•
Templet guide adapter
•
Lock nut
•
Collet cone 12 mm, 1/2"
•
Collet sleeve 6 mm, 8 mm, 10 mm
•
Collet sleeve 3/8", 1/4"
•
Wrench 24
•
Vacuum head set
Router bits
Straight bit
Fig.35
mm
D A L 1 L 2
6
1/4"
8 8 60 25
6
1/4"
6
1/4"
6 50 18
8 50 18
20 50 15
1/2"
12
1/2"
12
12 60 30
10 60 25
006452
"U"Grooving bit
Fig.36
mm
D A L 1 L 2 R
6 6 50 18 3
006453
"V"Grooving bit
Fig.37
mm
D A L 1 L 2
1/4" 20 50 15 90
006454