6
re-inserting the bit according to the instructions
above.
•
After inserting the bit, make sure that it is firmly
secured. If it comes out, do not use it.
Ring
1
2
3
012434
The hook is convenient for hanging the tool with hoist.
First, place the rope through the ring. Then hang the tool
up to the air with hoist.
CAUTION:
Before using the ring, always make sure that the bracket
and ring are secured and not damaged.
Hook
CAUTION:
After installing the hook, make sure that it is screwed
firmly.
1
2
3
008150
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw. To
remove, loosen the screw and then take it out.
OPERATION
CAUTION:
•
Always insert the battery cartridge all the way until it
locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you.
012430
Hold the tool firmly. Place the drill bit on the workpiece or
place the socket over the bolt or nut and turn the tool on.
For fastening operation, release the switch trigger after
the proper fastening time.
Drilling in wood
When drilling in wood, the best results are obtained with
wood drills equipped with a guide screw. The guide
screw makes drilling easier by pulling the bit into the
workpiece.
CAUTION:
•
Pressing excessively on the tool will not speed up
the drilling. In fact, this excessive pressure will only
serve to damage the tip of your bit, decrease the
tool performance and shorten the service life of the
tool.
•
There is a tremendous force exerted on the tool/bit
at the time of hole break through. Hold the tool
firmly and exert care when the bit begins to break
through the workpiece.
•
A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back
out. However, the tool may back out abruptly if you
do not hold it firmly.
•
Always secure small workpieces in a vise or similar
hold-down device.
•
If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Fastening torque
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
1. Groove
2. Screw
3. Hook
1. Bracket
2. Ring
3. Screws
