Makita MJV430, Instruction Manual

Page: 7 / 12

7
(4) Complete the cut in the normal manner.
Finishing edges
011290
To trim edges or make dimensional adjustments, run the
blade lightly along the cut edges.
Metal cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause significant blade wear.
The underside of the workpiece can be greased instead
of using a coolant.
Dust extraction
1
011291
Clean cutting operations can be performed by connecting
this tool to a Makita vacuum cleaner. Insert the hose of
the vacuum cleaner into the hole at the rear of the tool.
NOTE:
•
Dust extraction cannot be performed when making
bevel cuts.
Rip fence (optional accessory)
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before installing or removing
accessories.
1. Straight cuts
1
011292
When repeatedly cutting widths of 160 mm or less,
use of the rip fence will assure fast, clean, straight
cuts.
1
2
3
4
011293
To install, insert the rip fence into the rectangular
hole on the side of the base with the fence guide
facing down. Slide the rip fence to the desired
cutting width position, then tighten the bolt to
secure it.
2. Circular cuts
1
2
3
4
011294
1
011295
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
1. Rip fence
(Guide rule)
1. Threaded knob
2. Fence guide
3. Rip fence
(Guide rule)
4. Pin
1. Hex wrench
2. Bolt
3. Fence guide
4. Rip fence (Guide
rule)
1. Rip fence
(Guide rule)
1. Hose