7
Installing side grip
007955
CAUTION:
•
Always be sure that the side grip is installed
securely before operation.
Screw the side grip securely on the position of the tool as
shown in the figure.
Installing or removing wheel guard (For
depressed center wheel , multi disc / abrasive
cut-off wheel , diamond wheel)
For tool with locking screw type wheel guard
1
2
3
011221
1
2
3
011222
Mount the wheel guard with the tab on the wheel guard
band aligned with the notch on the bearing box. Then
rotate the wheel guard 180° clockwise or
counterclockwise. Be sure to tighten the screw securely.
Installing or removing depressed center
wheel (optional accessory)
1
2
3
4
003959
1
2
001649
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before installing or removing the wheel.
Mount the inner flange onto the spindle. (THE SIDE
WITH THE RUBBER SURFACE SHOULD CONTACT
THE WHEEL for rubber molded inner flange only. ) Fit the
wheel on over the inner flange and screw the lock nut
onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
OPERATION
WARNING:
•
It should never be necessary to force the tool. The
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
•
Continued use of a worn-out wheel may result in
wheel explosion and serious personal injury.
1. Lock nut wrench
2. Shaft lock
1. Lock nut
2. Depressed
centre wheel
3. Inner flange
4. Spindle
1. Wheel guard
2. Bearing box
3. Screw
1. Wheel guard
2. Bearing box
3. Screw
