QUICK START GUIDE
For protection, this compressor is shipped with a cap in
place of the air fi lter, so discard this cap and install the air
fi lter
(MAC700 & MAC2400 models only).
This unit is also shipped with a temporary cap in place of the
oil cap. Please discard this as well, and fi ll your pump with
oil
up to the
RED
dot
on the oil sight glass
.
Then proceed to
install the oil cap included in the accessory bag.
FIRST USE BREAK-IN PROCEDURE
1.
Open the air tank drain valve
2.
Plug power supply cord into correct power source
(the minimum requirement is 15 AMPS and a circuit
breaker is recommended)
3.
Turn the compressor
ON
by shifting the lever on the
pressure switch to the
ON position
and run the
compressor for twenty (20) minutes
4.
Close the air tank drain valve
This compressor is protected by an
OVERLOAD PROTECTION SWITCH
.
If the motor stops while the unit is set to
ON
:
1.
Turn the compressor
OFF
2.
Wait for the motor to cool (60 or more seconds)
3.
Press the
OVERLOAD PROTECTION SWITCH
(
RED
button located to left of pump under the shroud)
4.
Turn the compressor
ON
Fill with air compressor oil before starting
SAE 10W for cold weather (3° - 32°F)
SAE 20W for warm weather (33° - 80°F) - sample included
DO NOT USE MULTI-VISCOSITY MOTOR OILS LIKE 10W-30
YOUR COMPRESSOR IS NOW READY FOR OPERATIONAL USE
AVOID THE USE OF EXTENSION CORDS
Choose longer air hoses to reach fastening site
OVERLOAD PROTECTION SWITCH
WARNING
READ OWNERS MANUAL FOR COMPLETE INSTRUCTIONS
makitatools.com
SAE 10W
SAE 20W
(3° - 32°F)
(33° - 80°F)
0316 MA6186-16
CLOSED
OPEN
OIL SIGHT GLASS
DRAIN VALVE
OVERLOAD PROTECTION SWITCH
