24 ENGLISH
1
2
►
1.
0° Adjusting bolt
2.
Screw
Carefully square the side of the blade with the top
surface of the turn base using the triangular rule, try-
square, etc. by turning the 0° adjusting bolt clockwise.
Then tighten the knob firmly to secure the 0° angle you
have set.
1
2
3
►
1.
Triangular rule
2.
Saw blade
3.
Top surface of
turn base
Check if the side of the blade squares with the turn base
surface once again. Loosen the screw on the pointer.
Align the pointer with 0° position in the bevel angle
scale and then tighten the screw.
45° bevel angle
NOTICE:
Before adjusting the 45° bevel angle,
finish 0° bevel angle adjustment.
Loosen the knob and fully tilt the carriage to the side
that you want to check. Check if the pointer indicates
the 45° position in the bevel angle scale.
If the pointer does not indicate the 45° position, align
it with 45° position by turning the adjusting bolt on the
opposite side of the bevel angle scale.
1
2
►
1.
Left 45° adjusting bolt
2.
Right 45° adjusting bolt
Adjusting the laser line position
For model LS1019L only
WARNING:
The tool must be plugged in while
adjusting the laser line. Take extra care not to
switch on the tool during adjustment.
Accidental
start up of the tool may result in serious personal
injury.
Summary of Contents for LS1019L
Page 27: ...27 ...
