13 ENGLISH
To prevent the switch trigger from being accidentally pulled, a lock-off
button is provided. To start the tool, press in the lock-off button and
pull the switch trigger. Release the switch trigger to stop.
A hole is provided in the switch trigger for insertion of a
padlock to lock the tool off.
WARNING:
Do not use a lock with a shank or cable
any smaller than 6.35 mm (1/4") in diameter.
A smaller shank or
cable may not properly lock the tool in the off position and uninten-
tional operation may occur resulting in serious personal injury.
Electronic function
Constant speed control
The tool is provided with an electronic speed control which helps
maintain a constant blade rotation speed even under load. A
constant blade rotation speed will result in a very smooth cut.
Soft start feature
This function allows the smooth start-up of the tool by
limiting the start-up torque.
Laser beam action
For model LS1019L only
CAUTION:
Never look into the laser beam.
Direct laser beam may injure your eyes.
To turn on the laser beam, press the upper position (I) of the switch.
To turn off the laser beam, press the lower position (0) of the switch
1
►
1.
Switch for laser
Laser line can be shifted to either the left or right side of
the saw blade by turning the adjusting screw as follows.
1
►
1.
Adjusting screw
1.
Loosen the adjusting screw by turning it
counterclockwise.
2.
With the adjusting screw loosened, slide the
adjusting screw to the right or left as far as it goes.
3.
Tighten the adjusting screw firmly at the position
where it stops sliding.
NOTE:
Laser line is factory adjusted so that it is positioned within
1 mm from the side surface of the blade (cutting position).
NOTE:
When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to a
place where there is less direct sunlight.
Aligning the laser line
Align the cutting line on your workpiece with the laser line.
A
B
A) When you want to obtain the correct size on the left side of
workpiece, shift the laser line to the left of the blade.
B) When you want to obtain the correct size on the right side
of workpiece, shift the laser line to the right of the blade.
NOTE:
Use wood facing against the guide fence
when aligning the cutting line with the laser line at the
side of guide fence in compound cutting (bevel angle
45° and miter angle right 45°).
ASSEMBLY
WARNING:
Always be sure that the tool is
switched off and unplugged before working on
the tool.
Failure to switch off and unplug the tool may
result in serious personal injury.
Summary of Contents for LS1019L
Page 27: ...27 ...
