8
• Periodically check the level of the grass basket, and
empty before it becomes full.
NOTE:
• Using the electric lawn mower with the grass basket full
prevents smooth blade rotation and places an extra
load on the motor, which may cause breakdown.
Mowing a long-grass lawn
• Do not try to cut long grass all in one go. Instead, mow
the lawn in stages, leaving it for a day or two between
mows, until the lawn is evenly short.
1. Grass
NOTE:
• Mowing long grass to a short length all in one go may
cause the grass to die and/or block up the inside of the
main unit.
Transporting
CAUTION:
When carrying the electric lawn mower, make sure the
blade is on the outside (away from your body).
• Failure to do so may cause injury.
• To carry the electric lawn mower, secure the handle,
and carry as shown in the figure.
1. Handle
2. Blade is on the
outside
Storing
WARNING:
Be careful not to trap fingers between handle and lock
lever when storing away the electric lawn mower.
• If fingers do become trapped, it may cause injury.
Make sure that the handle is properly secured into the
handle stoppers on both sides of the top of the main
unit.
• Failure to do so may cause injury.
1. Handle
2. Grass basket
3. Hook
4. Handle stoppers
1. Remove the grass basket and shorten the handle.
(See the section titled “Extending handle” for details.)
2. Fold down the handle and stand up the device as
shown in figure.
3. Use the hook on the grass basket to hook it onto the
handle as shown in the figure.
MAINTENANCE
WARNING:
When changing the blade or inspecting and
maintaining the device, always turn OFF the Power
Switch, and unplug the power cord from the power
socket.
• Leaving the device plugged in may cause electric
shock or other accidents.
Always check that the blade has halted before
conducting above work.
• Failure to do so may cause injury.
When changing the blade or inspecting and
maintaining the device, always wear gloves.
• Failure to do so may cause injury.
CAUTION:
Do not use any wrench other than the provided
hexagonal wrench (accessory) when changing the
blade.
• Using a different wrench may lead to over-tightening or
looseness, which may cause injury.
Replacing the cylinder blade
1. Turn the main unit over, loosen the two lapping
adjustment screws and raise them up.
1. Spring
2. Lapping
adjustment
screws
2. Remove the two mounting screws from the side cover.
To remove the side cover, slightly slide it in the direction of
arrow (1) and then raise it in the direction of arrow (2) as
shown in the figure.
1
1
2
1
2
3
4
1
2