Standard Operating Procedure
Makita HM1810 Large Electric Breaker
Version 1 Issue date: 02/05/2017
Page 4 of 4
20 Goodshed Road Upper Hutt
Phone 04 528 4473
For bits without a collar:
Pivot the tool retainer front and slightly downward.
With the notched portion of the bit facing the tool
retainer shaft, insert the bit into the tool holder as
far as it will go. Then pivot the tool retainer further
downward toward the barrel to securely retain the
bit. Always ensure that the bit is securely retained by
attempting to pull the bit out of the tool holder.
Starting
Before plugging in the tool, always check to see that
the tool is switched off. (
To start the tool, simply squeeze the switch lever.
Release the switch lever to stop.
The green power-ON indicator lamp lights up when
the tool is plugged to the mains. If the indicator lamp
is lit but the tool does not start even if the tool is
switched ON, the carbon brushes may be worn out,
or the motor or the switch may be defective. Return
to Upper Hutt Hire.
Operation
Hold the tool firmly with both hands. Turn the tool on and apply slight pressure on the tool so
that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not
increase the efficiency.
Section 9: Transport
A. Disconnect from power source, roll up power cable and transport.
B. Ensure Chisel or point bits are removed from power tool
Section 10: Additional Information
Always use common sense! It is not possible to cover every conceivable situation you can face when using our
equipment. Always exercise care and use your common sense. Avoid all situations which you consider to be beyond
your capability. If you still feel uncertain about operating procedures after reading these instructions and the owner’s
manual, you should consult an expert before continuing.
The information contained herein is true and accurate to the best of our knowledge. No warranty or guarantee is
expressed or implied regarding the accuracy of information or instructions. Users MUST consult the manufacturer’s
manual or handbook. While every effort has been made to summarise the important Health and Safety information
for the safe use of this equipment, Upper Hutt Hire Ltd shall not be liable in any way for any reliance by any person or
entity on the accuracy of information or data contained in this document or its attachments.
Revision date
May 2022 (SOP based on HM1810 Manual ref 884604-371
