P 3/ 11
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Armature, Ball bearing 629DDW, Ball bearing 607LLB, Spiral bevel gear 10 (cont.)
DISASSEMBLING
Fig. 4
Fig. 5
Wrench 10
M6 Hex nut
Gear housing
Spiral bevel
gear 10
Spiral bevel
gear 10
Armature
Gear housing
Armature
Pull out Armature from Gear housing
by hand while holding Spiral bevel
gear 10 carefully not to be dropped.
(3) Remove M6 Hex nut on Spiral bevel gear 10. (
Fig. 4
)
(4) Remove Armature from Gear housing. (
Fig. 5
)
Guide plate
1R006
Fig. 6
Fig. 7
(5) Ball bearing 629DDW can be removed as illustrated in
Figs. 6 and 7
.
Note
: If the work mentioned in
Fig. 7
is not successful, do the step mentioned in
Fig. 8.
(6) Ball bearing 607LLB on Commutator end can be removed. (
Fig. 9
)
Strike Gear housing against work table.
Note:
Cover the work table with something soft to avoid
the damage on Gear housing before disassembling.
Ball bearing
629DDW
Ball bearing 629DDW
Retaining ring R-26
Remove Retaining ring
R-26 with 1R006.
Locking M6 Hex nut with Wrench 10,
turn Armature counterclockwise by hand.
Note
: If the above work is very difficult
due to the seizing of Spiral bevel
gear 10, spray a lubricant between
Armature shaft and Spiral bevel
gear 10, then turn and pull Armature
while holding Spiral bevel gear 10
with pliers and a cloth.
Spiral bevel
gear 10
M6 Hex nut
Set Armature, Spiral bevel gear 10 and M6 Hex nut
in place temporarily.
Retaining ring R-26 remains removed.
(
Refer to
Fig. 6.
)
Tap the edge of Gear housing
with plastic hammer.
Ball bearing 629DDW comes
with Armature.
Fig. 8
Fig. 9
Ball bearing 607LLB
1R269
Remove Labyrinth
rubber ring 19.
Remove Ball bearing
607LLB with 1R269.
Remove Insulation washer.
Labyrinth
rubber ring 19
Insulation
washer