![background image](http://html1.mh-extra.com/html/makita/ek6100/ek6100_instruction-manual_4180197018.webp)
18
IMPORTANT:
Because many of the parts and assemblies not mentioned
in this Instruction Manual are vital to the safety of the
unit, and because all parts are subject to a certain amount
of wear and tear, it is important for your own safety that
you have the unit checked and maintained regularly by a
MAKITA service center.
IMPORTANT:
If the cutting wheel breaks during cutting, the
Power Cut must be repaired by a MAKITA service
centre before being used again!
SERVICE
3
4
5
6
7
2
1
Changing the V-belt
Loosen bolts (
1
) and remove belt cover (
2
).
Move the V-belt pulley into the position shown.
Insert the Allen key into the hole (
3
) to block the V-belt pulley
(
5
).
Note:
Make sure that the V-belt pulley remains blocked.
Use the combination tool to turn the nut (
4
) about one turn
counter-clockwise.
Use the combination tool to turn the eccentric (
6
) forcefully
counter-clockwise to the position shown.
Remove the old V-belt (
7
) or belt fragments.
Clean out the interior with a brush.
Insert a new V-belt.
Use the combination tool to turn the eccentric (
6
) forcefully
clockwise to its original position (V-belt is now tight).
Tighten the nut (
4
).
Remove Allen key from hole (
3
).
Put the belt cover (
2
) on and tighten the bolts (
1
).
Note:
The V-belt is highly elastic, so it is not necessary to
retighten it.
A worn V-belt causes the cutoff disc turns at the lowest idle
speed. In this case, the V-belt must be replaced!