7 / 71
4-2
Blower Section
4-2-1
Removing Band complete L/R and Cushion
As for the REPAIR WORK of Cam gear, Muffler, Air cleaner plate, Carburetor, Insulator and Ignition coil, refer to
Fig. 6
1
Release Buckle [1] on Band complete from the top of
Frame as follows: with a tool such as long-nose pliers,
turn Buckle 90 degrees, then pull it out through the slot
of Frame. Release the other three Buckles from the
bottom of Frame in the same way.
Fig. 7
2
Lock rivet [1] fastening Band complete to Frame can
be removed by turning the center lock pin [2] of the
rivet counterclockwise with a Phillips screwdriver to
lift up the pin.
Tips
If the center lock pin [2] spins freely and cannot be
lifted up, turn the pin while lifting up Band complete
as shown on the left. (Remember this tip also when
removing Cushion.)
Lock rivet [1] can be removed from Band complete.
If it is removed, however, be careful not to lose the
center lock pin [2] because the pin will become easy
to fall off and get lost.
Fig. 8
3
Remove Cushion [1] from Frame by removing four
Lock rivets [2] with a Phillips screwdriver; first
remove the two rivets indicated by arrow 1, then
remove the two indicated by arrow 2.
1
2
[1]
[2]
1
2
[1]
[2]
[1]
[1]
