2
9 10
2
13
3
11
12
6
8
Guide the chain over the chain catch (
9
).
Pull the guide bar as shown by the arrow to take the slack
out of the chain, so that it comes up to the bottom edge of the
guide bar (
10
).
Pull the chain (
6
) around the sprocket nose (
8
) of the guide bar
in the direction of the arrow.
H
Tightening the saw chain
Slightly lift the end of the guide bar and turn the chain adjusting
screw (
13
) to the right (clockwise) until the chain rests against
the bottom side of the guide bar.
While still holding up the tip of the guide bar, tighten the retaining
nuts (
2
) with the universal wrench.
NOTE:
Before tightening the chain, loosen the two nuts (
2
) slightly.
Line up the holes in the sprocket guard (
3
) with the bolts (
11
).
Turn the chain tensioning screw (
H/13
) until the chain tensioning
bolt (
12
) is aligned with the hole in the guide bar.
Replace the sprocket guard.
Manually tighten the retaining nuts (
H/2
).
F
E
G
