6
Off
Blinking
Lighted
Indicator lamps
Charge the
battery.
0% to 25%
25% to 50%
50% to 75%
75% to 100%
Remaining
capacity
The battery
may have
malfunctioned.
015658
NOTE:
•
Depending on the conditions of use and the
ambient temperature, the indication may differ
slightly from the actual capacity.
Indication lamp with multi function
1
012513
Indication lamps are located in two positions.
When the battery cartridge is inserted on the tool with
the slide switch positioned in the "O (OFF)" position, the
indication lamp flickers quickly for approximately one
second. If it does not flicker so, the battery cartridge or
indication lamp has broken.
−
Overload protection
−
When the tool is overloaded, the indication
lamp lights up. When the load on the tool is
reduced, the lamp goes out.
−
If the tool continues to be overloaded and the
indication lamp continues to light up for
approximately two seconds, the tool stops.
This prevents the motor and its related parts
from being damaged.
−
In this case, to start the tool again, move the
slide switch to the "O (OFF)" position once
and then to the "I (ON)" position.
−
Battery cartridge replacing signal
−
When the remaining battery capacity gets
small, the indicator lamp lights up during
operation earlier than enough capacity
battery use.
−
Accidental re-start preventive function
−
Even if the battery cartridge is inserted on the
tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is
at work.
−
To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
Adjusting the depth of groove
1
2
3
4
012682
6 grooving depths can be preset according to the size of
biscuit to be used.
Refer to the table below for the correspondence
between the sizes marked on the stopper and the biscuit
size. Fine adjustments to the grooving depth can be
made by turning the adjusting screw after loosening the
hex nut. This may become necessary after the blade has
been resharpened a few times.
Size on stopper
0
10
20
S
D
MAX
Biscuit size
0
10
20
-
-
-
Depth of groove
8 mm
(0.3")
10 mm
(0.4")
12.3mm
(0.48")
14.7mm
(0.58")
13 mm
(0.51")
20 mm
(0.8")
*
* With the rubber spikes removed.
012683
Angle guide
The angle guide height can be moved up and down to
adjust the position of the blade in relation to the top of
the workpiece.
1
2
3
4
5
6
7
012497
1. Indication lamp
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
6. Tighten
7. Loosen
1. Pointer
2. Stopper
3. Adjusting screw
4. Rubber spike