Adjusting the parallelism
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1.
Set the tool to the maximum cutting depth.
2.
Make sure all levers and screws are tightened.
Slightly loosen the screw illustrated.
►
Fig.48:
1.
Screw
2.
Base
3.
While opening the lower guard, move the rear of
the base so that the distance A and B becomes equal.
4.
Tighten the screws and make a test cut to check
the parallelism.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual.
The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard
-
ing these accessories, ask your local Makita Service
Center.
•
Circular saw blade
•
Rip fence (Guide rule)
•
Hook
•
Guide rail
•
Bevel guide
•
Clamp
•
Sheet
•
Rubber sheet
•
Position sheet
•
Guide rail adapter
•
Rule bar
•
Dust nozzle
•
Hex wrench
•
Wireless unit (for DHS661)
•
Makita genuine battery and charger
NOTE:
Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
24 ENGLISH
Summary of Contents for DHS661RGJ
