[II] Disassembly/Assembly/Adjustment
1. Necessary Repairing Tools
2. Lubrication/Sealing
After you have disassembled the following parts, do lubrication or sealing as instructed below.
Needle bearing on clutch drum: Apply Makita grease N No. 2.
Spiral spring of recoil starter: Apply Makita grease N No. 2.
Engine: Apply Three bond 1215 to the contact surface between Crankcase and Cylinder.
Description
Use for
Tool No.
Bearing Setting Tool 20-12.2
1R028
Retaining Ring Pliers ST-2N
Disassembling/assembling kickback brake
(inertia chain brake) system
1R003
Bearing Setting Plate 12.2
Press-fitting Bearing to Crankshaft
1R034
Drill Chuck Remover 11
1R048
Copper Round Bar 20-100
Removing Flywheel
1R091
Air Tightness Tester
Testing Carburetor
1R127
T-type Hex Wrench 3-127
Removing/installing M4 Hex socket head bolt
1R170
T-type Hex Wrench 4-130
Removing/installing M5 Hex socket head bolt
1R171
1/4" Hex Shank Bit for M5
Removing Engine
1R229
Bearing Extractor
Removing Bearing from Crankshaft
1R269
13mm Hex Socket Bit
Removing/installing Clutch and Flywheel
Impact Driver (6990D, 6916D or the like)
Iron Hammer
Removing Flywheel
0.3mm Thickness Gauge
Fixing and adjusting Ignition coil complete
0.7mm Spark Plug Gauge
Adjusting spark gap of Spark plug
2 / 20