17
Failure to switch off and remove the battery cartridge
may result in serious personal injury from accidental
start-up.
•
Make sure that the cover of the nylon cutting head
is secured to the housing properly as described
below.
Failure to properly secure the cover may cause
the nylon cutting head to fly apart resulting in serious
personal injury.
(Fig. 36)
Press inward on the housing latches and lift upward to
remove the cover. Discard any of the remaining nylon
cord.
(Fig. 37)
Hook the middle of the new nylon cord to the notch
located at the center of the spool between the 2 channels
provided for the nylon cord. One side of the cord should
be about 80mm longer than the other side.
Wind both ends firmly around the spool in the direction
marked on the head for left hand direction indicated by
LH.
(Fig. 38)
Wind all but about 100 mm of the cords, leaving the ends
temporarily hooked through a notch on the side of the
spool.
(Fig. 39)
Mount the spool in the housing so that the grooves and
protrusions on the spool match up with those in the
housing. Keep the side with letters on the spool visible on
the top. Now, unhook the ends of the cord from their
temporary position and feed the cords through the eyelets
to come out of the housing.
(Fig. 40)
Align the protrusion on the underside of the cover with the
slots of the eyelets. Then push cover firmly onto the
housing to secure it. Make sure the latches fully spread in
the cover.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
TROUBLE SHOOTING
Before asking for repairs, conduct your own inspection
first. If you find a problem that is not explained in the
manual, do not attempt to dismantle the tool. Instead, ask
Makita Authorized Service Centers, always using Makita
replacement parts for repairs.