7 ENGLISH
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
9556HNR
9557HNR
9558HNR
Applicable grinding wheel
Max. wheel diameter
100 mm
115 mm
125 mm
Max. wheel thickness
6.4 mm
7.2 mm
Applicable cut-off wheel
Max. wheel diameter
105 mm
115 mm
125 mm
Max. wheel thickness
3.2 mm
Applicable wire wheel brush
Max. wheel diameter
100 mm
115 mm
125 mm
Max. wheel thickness
20 mm
Spindle thread
M10
M14 or 5/8″ (country specific)
Max. spindle length
18 mm
23 mm
No load speed (n
0
) / Rated speed (n)
11,000 min
-1
Overall length
271 mm
Net weight
1.9 - 2.9 kg
2.1 - 3.0 kg
Safety class
/II
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s). The lightest and heaviest combinations, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
Wear safety glasses.
Always operate with two hands.
Do not use the wheel guard for cut-off
operations.
DOUBLE INSULATION
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and its adaptation to national law,
used electrical and electronic equipment
should be collected separately and
delivered to a separate collection point
for municipal waste, operating in accor-
dance with the environmental protection
regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Intended use
The tool is intended for grinding, sanding, wire brush-
ing, hole cutting and cutting of metal and stone materi-
als without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
