P 7 / 8
W
iring diagram
[1] Connecting Lead Wire to Ring Terminal
Route Field lead wire to inside of Polyolefin tube. And then shrink the Polyolefin tube on the end of Ring terminal retainer
to cover the clamping position of the Ring terminal retainer to Field lead wire. See Fig. 22.
Ring terminal
Field lead wire
Ring terminal retainer
[2] Connecting Earth Terminals for Machine and Noise Suppressor
Connect Earth terminals with Motor housing so that each direction is the same as illustrated in Fig. 23.
[3] Wiring in Handle at Switch Installation Side
See Fig. 24 below.
Fig. 22
Fig. 24
Fig. 23
Polyolefin tube
Earth terminals
Handle
Earth lead wire between motor housing
and terminal block should ride on the
other lead wires and insert into lead wire
holder.
Noise suppressor
Place line coil, noise suppressor and connector in
the dot circle. After placing Noise suppressor,
install Line coil.
Slacken earth lead wire of power supply
cord as illustrated.
Slacken earth lead wire between motor housing
and terminal block as illustrated.
Do not route any lead wires onto the rib
for Terminal block.
Line coil
Connector
Lead wire holder
Earth lead wire of Noise suppressor
(transparent)
Earth lead wire for machine
(yellow and green)
Field Lead wires
(110V: water blue, 220-240V: blue or red)
Terminal
block